Replacing the Palm Rest Assembly

Place the palm rest assembly on the bottom case assembly. 2. Reinstall the three silver M2 x 6-mm screws in the keyboard-assembly area that secure the middle of the palm rest assembly to the bottom- case assembly. 3. Reinstall the four black M2 x 4-mm screws that secure the top of the palm rest assembly to the bottom-case assembly. 4. Connect the touch pad flex cable to the ZIF connector on the system board. 5. Connect the status lights flex cable to the ZIF connector on the system board. 6....

Removing the Display Assembly

Remove the two M2 x 5-mm screws at the back of the computer that secure the display assembly to the bottom case. 4. Turn the computer upside down on a flat work surface. 5. Remove the two M2 x 4-mm screws at the bottom of the computer that secure the display assembly to the bottom case. 6. Turn the computer right-side up. 8. Remove the left and right hinge covers. NOTICE When replacing the display assembly, the left hinge cover must go over the left hinge and the right hinge cover must go over...

Replacing the Display Assembly

Insert the left and right hinge posts into the holes at the top of the palm rest. 2. Carefully connect the LCD flex cable to the connector on the system board. 3. Place the LCD flex-cable hold-down clip over the LCD flex-cable connector. The word up is stamped on the top of the clip. The tab at the left of the clip should go under the palm rest, and the screw hole on the right side of the clip should line up with the holes in the connector ground strip and the threaded hole in the system board....

Speaker

Q NOTICE Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries. NOTICE To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer. NOTICE Read Preparing to Work Inside Your Computer before performing the following procedure. 2. Remove the display assembly. 3. Remove the keyboard assembly. 4. Remove the palm rest assembly. NOTICE To ensure maximum cooling for the microprocessor,...

Screw Placemat

M2 x 4 mm (2 each) M2 x 5 mm (2 each) M2.6 x 1.6 mm (6 each battery bay ) M2 x 4 mm (4 each black ) M2 x 6 mm (3 each silver ) M2 x 8 mm (2 each, with two rubber washers apiece) Some of the computer's interface connectors are ZIF connectors. These connectors are not removable, but they must be released to disconnect a cable from them. NOTICE The ZIF connectors are fragile. To avoid damage, do not apply too much pressure to the movable part of the connector. To disconnect an interface cable from...

Installing the NIC Driver for Windows Millennium Edition Me

Save your work and insert your Drivers and Utilities CD. You may close the CD interface if desired before continuing with the procedure. 2. Click the Start button, point to Settings, and click Control Panel. 3. In the Control Panel, double-click the System icon. J NOTICE To see the System icon, you may need to click View all control panel options at the left side of the screen. 4. In the System Properties window, click the Device Manager tab. 5. Double-click Network Adapters, and then...