Replacing the Display Assembly Latch

1. Carefully place the latch spring over the post on the display-assembly top cover.

You may need to use a small flat-blade screwdriver to place the spring over the post. Hold the spring on the post with the screwdriver while performing the next step.

2. Holding the latch, stretch the spring slightly and set the display- assembly latch in place in the display assembly top cover.

3. Reinstall the bezel.

LCD Panel

M2x3.5mm

Q NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.

NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

NOTICE: Read "Preparing to Work Inside Your Computer" before performing the following procedure.

Was this article helpful?

0 0

Post a comment