Hinge Saddles

This section provides the removal procedure for the hinge saddles.

Suspended Ceiling Details

Figure 4-40. Hinge Saddle Removal

Figure 4-40. Hinge Saddle Removal

This procedure assumes that you have removed the PC Card heat sink and

LVDS board. To remove the hinge saddles, follow these steps (see

1. Remove the four 4-mm screws from the top of the left and right hinge saddles.

2. Remove the four 4-mm screws from the back of the computer above the ports.

3. Remove the 10-mm screw and 20-mm screw from the right hinge saddle and remove the saddle.

4. Remove the 10-mm screw and 20-mm screw from the left hinge saddle and remove the saddle.

5. Disconnect the LED cable from connector J6 on the system board.

6. Remove the 6-mm screw from the plastic frame, remove any tape, and remove the plastic frame.

RJ-11 Card

This section provides the removal procedure for the RJ-11 card.

Romeinse Villa Tekening
Figure 4-41. RJ-11 Card Removal

To remove the RJ-11 card, follow these steps (see Figure 4-41):

1. Remove the 4-mm screw securing the RJ-11 card to the system board.

2. Lift the card off the system board.

Was this article helpful?

0 0

Post a comment