Processor Board Removal

Figure 21. Processor Board Components

1 Processor board

This procedure assumes that you have removed the heat exchanger/fan. To remove the processor board (see Figure 20), perform the following steps:

1. Remove the three 5-mm screws securing the processor board to the system board.

2. Gently pull the processor board off of connector JP15 on the system board. Do not rock the board to remove it, because this may damage the connectors.

When reinstalling the processor board, align the board with the notch on the system board connector. Press down on the left side of the board over the system board connector. This is the best spot to apply pressure to seat the processor correctly on connector JP15.

Was this article helpful?

0 0

Post a comment