Removing the Memory Module Modem Cover

Xa NOTE: This procedure covers removing and replacing the memory module located under the memory module/modem cover on the bottom of the computer. A second memory module resides on the upper surface of the system board under the critical component shield. To replace the memory module under the critical component shield, perform the procedure for removing the palm rest up to and including removal of the critical component shield. Then replace the memory module.

(J) NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.

(J) NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

Q NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure.

1. Turn the computer over, and use a #1 Phillips screwdriver to release the two captive screws from the memory module/modem cover.

2. Place your finger under the cover at the indentation, rotate the cover open, and remove it.

Was this article helpful?

0 0
The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook

Post a comment