Caution Before performing the following procedures read the safety instructions in your System Information Guide

Q NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

(J) NOTICE: You must remove the display assembly before you remove the palm rest.

1. Follow the instructions in "Preparing to Work Inside the Computer."

2. Remove the keyboard.

3. Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.

4. Loosen the captive screw that secures the display cable to the system board, and release the cable from the four cable-routing clips.

1

M2.5 x 6-mm screws (3)

2

display cable connector

3

display

4

computer base

5

pull-tab

6

system board connector

7

captive screw

8

cable-routing clips (4)

5. Pull up on the pull-tab that is attached to the display cable connector to remove the connector from the system board.

6. Remove the three M2.5 x 6-mm screws.

7. Rotate the display assembly to a 90-degree angle, and lift the display assembly up and out of the computer base.

1

display

2

computer base

1 display bumpers (6) 4 display panel

2

M2 x 5-mm screws (6)

5

top cover

3

display bezel

6

M2 x 5-mm screws (4)

The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook


Post a comment