Display Assembly Base

To remove the display assembly base (see Figure 4-14), follow these steps:

1. Remove the display assembly from the computer. See "Display Assembly" in Chapter 4.

2. Remove both hinge covers.

See "Hinge Covers" in Chapter 4.

3. Rotate the display assembly hinges so that they point away from the display assembly at approximately 180 degrees.

4. Remove the display assembly bezel.

See "Display Assembly Bezel" in Chapter 4.

5. Remove the left hinge.

See the next subsection, "Display Assembly Hinges."

6. Rotate the right end of the display assembly base away from the display assembly until the base clears the right hinge.

7. Lift the display assembly base away from the left hinge.

8. Disengage the display-assembly interface cable from the slot in the base.

0 0

Post a comment