Display Assembly EMI Shield

display assembly case display assembly case

EMI shield

5. Remove the LCD-inverter-board.

See "LCD-Inverter-Board Interface Cable" in Chapter 4.

6. Remove the display assembly base.

See "Display Assembly Base" later in this chapter.

7. Remove the display-assembly EMI shield.

The EMI shield is held in place by tabs along the upper and lower edges. Pulling the center of the shield slightly away from the display assembly will release the tabs.

To replace an EMI shield, carefully orient the replacement EMI shield in the same position as the original shield. Make sure that all screw holes in the shield are aligned with their corresponding screw holes in the display assembly case.

0 0

Post a comment